SLN(4) BSD Kernel Interfaces Manual SLN(4)NAMEsln — Silan SC92031 10/100 Ethernet device
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device sln
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
if_sln_load="YES"
DESCRIPTION
The sln driver provides support for Ethernet adapters based on Silan's
SC92031 chip.
The sln driver supports the following media types:
autoselect Enable autoselection of the media types and options.
10baseT/UTP Set 10Mbps operation. The mediaopt option can also be used
to select either full-duplex or half-duplex modes.
100baseTX Set 100Mbps (Fast Ethernet) operation. The mediaopt option
can also be used to select either full-duplex or half-duplex
modes.
The sln driver supports the following media options:
full-duplex Force full duplex operation.
half-duplex Force half duplex operation.
For more information on configuring this device, see ifconfig(8).
HARDWARE
The following cards are among those supported by the sln driver:
· Noganet KN-8139D
SEE ALSOarp(4), pci(4), ifconfig(8)HISTORY
The sln driver first appeared in DragonFly 1.13 as a port of a
FreeBSD 4.7 driver provided by Silan.
AUTHORS
The sln driver was originally written by gaoyonghong and ported to
DragonFly by Sascha Wildner.
BSD February 28, 2008 BSD