RTQUERY(8) BSD System Manager's Manual RTQUERY(8)NAMErtquery - query routing daemons for their routing tables
SYNOPSISrtquery [-1np] [-r addr] [-t op] [-w timeout] host ...
DESCRIPTIONrtquery is used to query a RIPv1/2 network routing daemon for its routing
table by sending a request command. The routing information in any rout-
ing response packets returned is displayed numerically and symbolically.
rtquery is also used to turn tracing on or off.
See routed(8) for more information about a RIPv1/2 capable routing dae-
mon.
The options are as follows:
-1 Query using RIP version 1 instead of RIP version 2.
-n Normally network and host numbers are displayed both symbolically
and numerically. The -n option displays only the numeric network
and host numbers.
-p Uses the poll command to request full routing information, in-
stead of the default request command.
-r addr
Ask about the route to destination addr.
-t op Change tracing, where op is one of the following. Requests from
processes not running with UID 0 or on distant networks are gen-
erally ignored by the daemon except for a message in the system
log.
dump Dumps the daemon's routing table to the current
tracefile.
more Increases the debugging level.
off Turns off tracing.
on=tracefile
Turn tracing on into the specified file. That file
must usually have been specified when the daemon
was started or be the same as a fixed name, often
/etc/routed.trace.
-w timeout
Changes the delay for an answer from each host. By default, each
host is given 15 seconds to respond.
SEE ALSOrouted(8)
Routing Information Protocol, RIPv1, RFC 1058, June 1988.
Routing Information Protocol, RIPv2, RFC 1723, November 1994.
MirOS BSD #10-current June 1, 1996 1