getvol(1M) System Administration Commands getvol(1M)NAMEgetvol - verifies device accessibility
SYNOPSIS
/usr/bin/getvol -n [-l label] device
/usr/bin/getvol [-f | -F] [-ow] [-l label | -x label] device
DESCRIPTIONgetvol verifies that the specified device is accessible and that a vol‐
ume of the appropriate medium has been inserted. The command is inter‐
active and displays instructional prompts, describes errors, and shows
required label information.
OPTIONS
The following options are supported:
-n Runs the command in non-interactive mode. The volume is
assumed to be inserted upon command invocation.
-l label Specifies that the label label must exist on the inserted
volume (can be overridden by the -o option).
-f Formats the volume after insertion, using the format com‐
mand defined for this device in the device table.
-F Formats the volume after insertion and places a file system
on the device. Also uses the format command defined for
this device in the device table.
-o Allows the administrator to override a label check.
-w Allows administrator to write a new label on the device.
User is prompted to supply the label text. This option is
ineffective if the -n option is enabled.
-x label Specifies that the label label must exist on the device.
This option should be used in place of the -l option when
the label can only be verified by visual means. Use of the
option causes a message to be displayed asking the adminis‐
trator to visually verify that the label is indeed label.
OPERANDS
The following operands are supported:
device Specifies the device to be verified for accessibility.
EXIT STATUS
The following exit values are returned:
0 Successful completion.
1 Command syntax was incorrect, invalid option was used, or an
internal error occurred.
3 Device table could not be opened for reading.
FILES
/etc/device.tab
ATTRIBUTES
See attributes(5) for descriptions of the following attributes:
┌─────────────────────────────┬─────────────────────────────┐
│ ATTRIBUTE TYPE │ ATTRIBUTE VALUE │
├─────────────────────────────┼─────────────────────────────┤
│Availability │SUNWcs │
└─────────────────────────────┴─────────────────────────────┘
SEE ALSOattributes(5)NOTES
This command uses the device table to determine the characteristics of
the device when performing the volume label checking.
SunOS 5.11 5 Jul 1990 getvol(1M)